Home » Sierra Monitors' Sentry Gas Detection System
Sierra Monitors' Sentry Gas Detection System
By Sierra Monitors
Wastewater treatment facilities are located in every community and region of the country. The process of treating the wastewater results in the use or production of a range of combustible and toxic gases that are a danger to the plant and personnel. In addition, there are many enclosed spaces in a wastewater treatment plant where toxic gases can build up or non-toxic gases can deplete the oxygen making it dangerous to plant personnel.
Portable monitors can only protect the individual wearing the monitor and are not capable of protecting the entire plant or to protect areas where personnel are not present. Fixed gas detection systems are necessary for these areas.
The Sentry Gas Detection System, Analog gas detectors and gas alarm monitors all have their place in this industry depending upon the scope of the potential hazard.
Areas with potential hazardous levels of gases include:
- Pumping station -- Combustible gas, oxygen, hydrogen sulfide
- Influent and barscreen room -- Combustible gas, oxygen
- Barscreen and conveyor room -- Combustible gas
- Barscreen container and grit screen room -- Combustible gas
- Clarifier (with cover) -- Oxygen, hydrogen sulfide
- Primary wet well -- Combustible gas, oxygen, hydrogen sulfide
- Grit chamber and wet well -- Combustible gas, oxygen, hydrogen sulfide
- Sludge distribution chamber -- Combustible gas, oxygen, hydrogen sulfide
- Basement - generator area -- Combustible gas
- Digester - basement -- Combustible gas, hydrogen sulfide
- Digester - first floor -- Combustible gas, hydrogen sulfide
- Filtration room -- Hydrogen sulfide
- Odor removal equipment -- Hydrogen sulfide
- Furnace room -- Combustible gas, carbon monoxide
connected to the controller by using any standard 4-20mA output from such devices as an ultrasonic level device, a magnetic flow meter, and pH detectors. The Sentry Controller allows for separate input identification screen labels such as "Hydrogen Sulfide" for gas detection, "GPM" for flow rate, "Inches" or "Feet" for level, and so on. Real-Time values are also displayed at the controller display.
All of these inputs are processed at the controller and provide a single serial output for all data gathered at the controller via Modbus RS-232 output. This Serial output provides easy access to the SCADA system without any special hardware or programming typically required if these individual analog signals were converted to serial outputs.
The FieldServer Gateway provides the interface necessary for safety devices, process equipment and facility controls so that these various individual systems and evices can communicate to the distributed control systems found in such plants operating on DH+, Profibus, Modbus, ControlNet or EtherNet/IP.
Alarm Mobility Increases Hydro Plant Reliability
integrating the TopView Alarm Notification Software with the SCADA System, Operators Are Now Able to Receive Alarm Messages in Real-Time on Their Cell Phones and Can Acknowledge These Alarms from Anywhere
- 05/09/2013 groov gets IOS and Android apps
- 05/01/2013 Swagelok publishes comprehensive sampling systems reference book
- 05/01/2013 Krohne provides instrumentation for Chobani plant
- 04/19/2013 Attendees Learn About Suppliers' Latest Foundation Products
- 04/19/2013 Huang Buyu, Now Retired from Sinopec SEI, Is Honored
- 04/19/2013 Dave Glanzer Addresses General Assembly Attendees
- 04/19/2013 FOUNDATION Fieldbus-Certified Training Center
- 04/19/2013 FOUNDATION Fieldbus Technology Helps Power Company Save
- 04/19/2013 Foundation for Remote Operations Management (ROM) Provides an Extended Information Architecture
- All news »
Access the entire print issue on-line and be notified each month via e-mail when your new issue is ready for you. Subscribe today.
- Featured White Papers