WirelessHART monitors StatoilHydro Gullfaks platforms

May 28, 2009

AUSTIN, Texas -- Using open WirelessHART products, Emerson Process Management’s Smart Wireless network is automating flow monitoring to increase production on StatoilHydro’s Gullfaks offshore platforms in the northern part of the Norwegian North Sea. Needing a monitoring approach able to be installed without interrupting flow, operators are using wireless devices to transmit real-time temperature data that indirectly monitors flow, allowing quick reaction to any loss of well pressure and maximizing throughput from the well. This installation follows the success of Smart Wireless on StatoilHydro’s Grane platform.

StatoilHydro, the leading oil and gas operator on the Norwegian continental shelf, was occasionally losing flow from the producing wells at its Gullfaks A, B and C platforms, caused by a loss of wellhead pressure. Early detection of the loss of flow is important as this enables operators to flow the well through the test separator and thus re-establish flow by reducing pressure. Bringing flow back quickly improves throughput and over time significantly increases production.

The loss of flow was very difficult to detect due to there being no existing flow-metering devices installed within the well pipes. Installing such devices for this application was not practical as this would require a complete shutdown of production, which would be far too expensive in terms of lost throughput. A non-intrusive solution was required, but the introduction of new sensors brings with it the problem of connecting them back to the control room. The wellhead was already a very crowded area and for safety reasons it had to be kept as clear as possible. The introduction of additional equipment such as new cabling, cable trays and junction boxes was not possible.

In the past, StatoilHydro detected loss of flow by sending an operator to the wellhead where he placed his hand on the pipe to feel whether there was a difference between the pipe temperature and the ambient temperature. Typically well fluid is 60° C so the pipe feels warm, but should flow be interrupted, it slowly drops back to the ambient temperature. Temperature readings were taken only at the start and the end of a shift, so a loss of flow could easily go undetected for long periods, and production would be lost.

Needing to automate the monitoring so as to provide real-time data, while also reducing personnel presence in hazardous areas, StatoilHydro initially implemented a pilot installation on the Gullfaks A, B & C platforms. Emerson 648 wireless temperature transmitters were installed to indirectly indicate flow on lines at each of forty wells. The wireless devices are used to transmit data from clamp-on temperature sensors mounted on the surface of the flow pipes.

“Installing additional wired measurement points at the wellhead would mean long cable trays and a lot of wiring,” said Anders Røyrøy, Project Manager, Research & Development Projects, StatoilHydro Norway. “Wireless offers an inherent reduction in cabling infrastructure, complexity and weight, resulting in significantly lower installation costs.”

“Because there is daily radio communication within the well area, it is essential that the wireless field network can coexist without any reduction in performance,” continued Røyrøy. “We have found that Emerson’s Smart Wireless mitigates the impact of interference and the data reliability is 100%.”

In contrast with the once-a-shift manual recordings, Emerson’s wireless devices now transmit readings every 30 seconds back to the Smart Wireless Gateway. The gateway is hardwired straight into the existing control system providing operators with the real time information they need to react quickly to any change in flow.

StatoilHydro has now implemented additional Smart Wireless devices on Platforms A, B and C, bringing the total to 90 wireless transmitters covering all production flow lines at Gullfaks.

“Rich process information and plant diagnostics are essential for unmanned operation and by introducing Smart Wireless transmitters to our platforms we are making broad strides towards our aims,” said Røyrøy.